You can install a SharkSkin® wrap on your VTM machine yourself. No professional installer or special training is needed. The video below walks through the full install from start to finish, and the written steps follow the same order so you can work along with it.
Compatible machines
Mini Wall
Slim Wall
Mega Wall 2.0
Slim Tower 2.0
Watch the install
Tools you'll need
Alcohol solution (isopropyl)
Microfiber towel
Razor knife
Squeegee (optional, but it makes smoothing easier)
Before you begin
Work indoors in a clean, low-dust area. Any dust trapped under the vinyl will show as a bump.
Lay out all of your wrap pieces and match each one to its panel (front, left side, right side) before peeling any backing.
If you are also installing a Pedestal Stand, do that first. The stand install involves flipping the machine, which can scuff a fresh wrap. See Universal Pedestal Stand Installation.
Take your time. Peel the backing a little at a time instead of removing it all at once.
Step 1: Clean the surface (watch at 0:19)
Wipe down every surface you'll be wrapping with alcohol solution on a microfiber towel. This removes dust, grease, and fingerprints so the wrap bonds properly. Let the surface dry completely before applying any vinyl.
Step 2: Apply the front pieces (watch at 0:43)
Line up the first front piece before it touches the machine. Peel back a small section of the backing, set the top edge in place, then smooth the wrap outward from the center as you pull the rest of the backing away. Repeat for each front piece, keeping the edges aligned with the panel.
Step 3: Apply the left side (watch at 3:20)
Use the same technique on the left side panel. Align the piece, set one edge, and smooth from the center outward. Once it's down, trim any excess along the edges with the razor knife.
Step 4: Apply the right side (watch at 5:40)
Repeat the process on the right side panel, then trim the edges.
Tips for a clean finish
Always smooth from the center toward the edges. This pushes air out instead of trapping it.
If a piece goes on crooked, gently lift it and reapply before pressing it down firmly.
Push small air bubbles toward the nearest edge with the squeegee or your towel.
When trimming, use light pressure and follow the panel edge. Keep the razor away from the glass, the display, and any rubber seals.
Need help?
If a wrap piece arrives damaged, looks misprinted, or doesn't fit your machine, message VTM Support through chat and include a photo. We'll help sort out replacement pieces.